10.2190/CK0Q-NUUE-1522-3AFE CK0QNUUE15223AFE 3 Flyash Characteristics and Its Incorporation Effects on Soil Health 391 399 20020509 20020509 20020509 20020509 CK0QNUUE15223AFE.pdf http://baywood.metapress.com/link.asp?target=contribution&id=CK0QNUUE15223AFE 4 Naveen Kalra Anita Chaudhary Himanshu Pathak H. C. Joshi M. C. Jain S. K. Sharma Vinod Kumar Indian Agricultural Research Institute, New Delhi, India The disposal of huge amounts of ash produced in modem society is a major concern. Although this material finds uses in civil construction, cost considerations have limited such applications. the use of ash as landfill or for reclaiming acid/sodic soils are major disposal options, but these are not able to utilize the appreciable amount of ash produced. Thermal power stations thus require large spaces for storage, which may bring drastic changes in land-use patterns in the areas nearby. Authorities may have to maintain stricter associated air and water pollution limits. This article reports ash characteristics, ambient air quality, and ash incorporation effects on soil health at the National Capital Power Project (NCPP), Dadri, Ghaziabad, Uttar Pradesh, which is the only single dry ash disposal unit using electrostatic precipitation collection devices in India. the low particle density of ash establishes its potential for dust formation. the high water-holding capacity of ash is due to characteristic silt and clay size fractions. Ninety-three percent of the ash is composed of oxides of silicon, aluminium and iron. pH is neutral to slightly alkaline, whereas electrical conductivity was 0.65 mmhos/cm. Heavy metals, present in the oxide forms, in flyash exhibited concentrations considerably higher than in coal and in normal soils. Dust fall rate, averaged annually, in adjoining villages lay in a range of 4.91-15.92 g/m3/30d, indicating ash fall, on annual basis, of less than 1 percent of surface soil mass. the fall rates were high during dry summer season, decreased in rainy season, and thereafter increased as winter progressed. Ambient air quality in villages adjoining NCPP was maintained well within safe limits, due to management controls adopted by the authorities. Addition of flyash (up to 40% ash in the soil-ash admixture) decreased bulk density and hydraulic conductivity, whereas enhanced moisture retained at field capacity, wilting point and surface mechanical impedance, primarily due to modifications in pore size distribution from ash addition. Differences in physico-chemical characteristics over the Control (no ash) due to ash incorporation were narrowed with time, indicating a high buffering capacity of the soil. Microbial activity was enhanced by ash incorporation up to 5 percent ash level in the soil-ash admixture. Thereafter inhibitory symptoms in the microbial activities were noticed. This trend was not observed in agricultural fields around Thermal Power Station, which were exposed to ash-added environments for longer periods of time.

V. N. Nagaraja Rao, S. Seetharamu, and B. H. Narayana, Assessment of Environmental Pollutions in Coal Fired Thermal Power Plants, paper presented at National Seminar on Environmental Aspects of Thermal Power Plants Organised by R&D Centre, NTPC, Noida, U. P., India from December 9-10, 1993.

V. P. Deshpande, C. K. Kale, S. K. Gadkari, and Badrinath, Environmental Impacts Due to Flyash from Coal Fired Thermal Power Plants, paper presented at National Seminar on Environmental Aspects of Thermal Power Plants Organised by R&D Centre, NTPC, Noida, U. P., India from December 9-10, 1993.

R. N. Garg, G. Singh, N. Kalra, D. K. Das, and S. Singh, Effect of Soil Amendments on Soil Physical Properties, Root Growth and Grain Yields of Maize and Wheat, Asian Pacific Journal of Environment, 3:1, pp. 54-59, 1996.

L. C. Mishra and K. N. Shukla, Effects of Flyash Deposition on Growth, Metabolism and Dry Matter Production of Maize and Soybean, Environmental Pollution, 42, pp. 1-3, 1986.

R. Sikka and B. D. Kansal, Characterization of Thermal Power Plant Flyash for Agronomic Purposes and to Identify Pollution Hazards, Bioresource Technology, 50, pp. 269-273, 1994.

N. B. Singh and M. Singh, Effects of Flyash Application on Saline Soil and on Yield Components, Yield and Uptake of NPK of Rice and Wheat at Varying Fertility Levels, Annals of Agricultural Research, 7:2, pp. 245-257, 1986.

J. J. Hanway and H. Heidal, Soil Analysis Methods Used in Iowa State College Soil Testing Laboratory, Iowa Agronomist, 57, pp. 1-31, 1952.

M. L. Jackson, Soil Chemical Analysis, Prentice Hall of India, Pvt. Ltd., New Delhi, India, 1973.

J. R. Pichtel and J. M. Hayes, Influence of Flyash on Soil Microbial Activity and Populations, Journal of Environmental Quality, 19, pp. 593-597, 1990.

A. L. Page, A. A. Elseewi, and I. R. Straughan, Physical and Chemical Properties of Flyash from Coal Fired Power Plants with Reference to Environmental Impacts, Residue Review, 71, pp. 83-120, 1979.